Silvercrest SEK 2000 A1, Инструкция по эксплуатации и технике безопасности

Страница: 13 / 31

GB/IE/NI 14
- Setting the brightness levels
Push this button to set various brightness levels. The
stair display
H
on the display shows the currently
set step.
- Setting the heating levels
Push this button to set the heating levels.
The symbols
B
on the display show the currently set
heating level.
1 LED = heating level 1 (900 W)
2 LEDs = heating level 2 (1850 W)
No LED = The appliance heating function is switched
off. The fan continues to run for 10 seconds.

Operation via remote control
REMOTE CONTROL:
INSERTING OR REPLACING THE BATTERY
A lithium button cell is supplied with the remote cont-
rol. To operate the remote control, remove the plastic
strap that protrudes from the battery compartment
13
.
(see Fig. 6)
If the battery in the remote control needs to be repla-
ced, insert a new 3-volt lithium button cell. Pay attention
to the type of lithium button cell (CR2025).
Press the tab
12
on the remote control battery
compartment
13
toward the centre. Now pull
out the battery compartment
13
. (See Fig. 7)
Remove the used battery.
Insert a new CR2025 3 V button cell, observing
the correct polarity.
Slide the battery compartment
13
back into the
remote control until the tab
12
snaps into place.
- Switching on the Curved electric built-in fire :
Push this button to start the preheating process. The
fire begins to blaze.
- Setting the day
Press this button to start the weekday setting. Use the
“+” and “-” keys to set the weekdays.
- Setting hours
After pressing this button, you can set the hours with
“+” and “-”.
- Setting minutes
After pressing this button, you can set the minutes
with “+” and “-”.
- Setting system time/timer
Press this button to set the current time, day of the week
or timer. Use the “+” and “-” keys to set the weekdays. To
set the hours and minutes, follow the description of each
6
7
8
Heating levels
Brightness
Day
Hours
Timer
Minutes
SET UP