Silvercrest SDM 1500 D2, Руководство по эксплуатации

Страница: 31 / 130

■ 28
│
GB│IE
SDM 1500 D2
Operation
CAUTION! PROPERTY DAMAGE!
► If you are not sure whether the floor is suitable for cleaning, please carry
out a tolerance test using a concealed part of the floor .
► Always comply with the cleaning instructions of the carpet manufacturer .
Before cleaning, check also whether the carpet is suitable for steam
cleaning .
► Never use the appliance without a pad
6
/
o
on the steam foot
5
.
Otherwise the floor could get scratched!
► Never operate the appliance without water in the water tank
8
!
The pump could overheat and be damaged!
NOTE
► Before you clean the floor with the steam mop, we recommend that you
vacuum the floor to remove any loose particles of dirt .
Once the appliance is assembled and filled with water:
1) Flip the handle upwards so that the “Handle” release button
1
clicks into
place .
2) If not already done: Completely unwind the power cable from the cable
hooks
z
/
i
. To facilitate the unwinding of the cable, you can flip down the
upper cable hook
z
by pulling it out a little and turning it at the same time .
3) Run the cable through the notch
t
on the rear of the handle so that the
cable does not hang down into the working area .
4) Insert the plug into the mains power socket .
5) Set the on/off switch
u
to “I” . The on/off switch
u
lights up, the red
POWER control lamp
0
flashes . As soon as the appliance has warmed up
(after approx . 25 seconds), the red POWER control lamp
0
lights up
continuously .
6) Use the MODE button
e
to select the desired level of steam generation:
–
Press 1 x: low steam level, green control lamp
w
lights up .
–
Press 2 x: high steam level, red control lamp
q
lights up .
–
Press 3 x: no steam, standby, POWER control lamp
0
lights up .