Silvercrest SDM 1500 D2, Руководство по эксплуатации

Страница: 32 / 130

GB│IE
│
29 ■ SDM 1500 D2
NOTE
► We recommend the high steam level especially for moisture­ and
heat­resistant floor coverings, such as tiles .
► We recommend the low steam level especially for moisture­ and
heat­sensitive floor coverings, such as parquet flooring .
7) Press the “Steam” button
r
. The appliance starts generating steam and,
after a short time, steam is emitted through the pad
6
/
o
.
8) Wipe over the desired area .
NOTE
► Once the water tank
8
has been pumped empty, the pump will continue
running a little while until the empty water tank
8
is indicated by the
simultaneous flashing of the red control lamp
q
, the green control lamp
w
and POWER control lamp
0
.
If the water tank
8
becomes empty during use:
–
Press the “Steam” button
r
again to stop steam production .
–
Set the on/off switch
u
to “O” .
–
Remove the water tank
8
, fill it and replace the water tank
8
as
described in the section “Filling with water” .
–
Set the on/off switch
u
to “I” .
–
Select the desired steam level as described above and press the
“Steam” button
r
.
9) When you are finished treating all of the surfaces, press the “Steam”
button
r
to stop steam production .
10) Set the on/off switch
u
to “O” . The POWER control lamp
0
goes out .
11) Remove the power plug from the mains power socket .
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may be
due to the previously used cleaning fluids . Simply clean the floor again
using the steam mop . The smears should now be gone .