Silvercrest KH 2158, Руководство по эксплуатации

Страница: 19 / 82

- 17 -
System reset
Via this function you can reset the URC to its factory default
settings. Thereby all settings made by you will be deleted.
1.
Hold down the S button
r
for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the

or

button
t
select "SYSTEM SETUP" and
confirm with the OK button
l
.
3. With the

or

button
t
select "SYSTEM RESET" and
confirm with the OK button
l
.
4. In the LCD display
q
now appears "CONFIRM RESET".
Confirm the reset with the OK button
l
. Then the LCD
display
q
shows “SUCCESS RESET”. All settings are
now deleted and the menu is closed. Otherwise you can
exit the menu by pressing the EXIT button
y
. Then the set-
tings remain preserved.
Timer Setup
The URC offers 2 timer modes, sleep timer and event timer.
Sleep timer
1. Press the device button
e
for the device that is to be con-
trolled (i.e. VCR).
2. Hold down the S button
r
for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
3. Press the

or

button
t
until "TIMER SETUP" is
shown. Press the OK button
l
"TIMER SLEEP" appears in
the LCD display
q
. Confirm the selection of this function
with the OK button
l
.
4. Now, below to the right in the LCD display
q
blinks the
minutes for the remaining time of the selected device.
Set with the

or

button
t
the desired value from 1
to 99 minutes. Press the OK button
l
to confirm. With
programmed sleep-timer the LCD display
q
shows “ z
z”
on the right next to the time.
5. Position the remote control in such a way that your infra-
red signal can reach the device to be switched off. After
expiration of the set time the remote control will switch the
device off.
6. If you now press the S button
r
“SL” is shown in the dis-
play
q
below on the left.
Event timer
The remote control has 4 event timers available via which
you are allowed to send out specific series of button combi -
nations at designated times.
1. Hold down the S button
r
for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the

or

button
t
select "TIMER SETUP" and
confirm with the OK button
l
. "TIMER SLEEP" appears
in the LCD display
q
. With the

or

button
t
select
the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button
l
.