Silvercrest HG03848, Инструкции по эксплуатации и безопасности

Страница: 8 / 38

8 GB/IE/NI
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the bat-
tery / rechargeable battery and
the product.
Clean the contacts on the bat-
tery / rechargeable battery and
in the battery compartment be-
fore inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before use
Remove all parts from the packaging.
Note: Remove all packaging material from
the product.
Installing / replacing batteries
(see Fig. A)
Press “0” on the On / Off
button
1
before installing the batteries
3
.
Open the battery compartment by squeezing
the dots located on front and back of base of
handle and pull off the cap
2
.
Slide out the battery tray
4
.
Insert / replace 4 batteries 1.5 V AA
3
into
the battery tray
4
, noting the polarity (+ and -).
The polarity is indicated inside the battery
tray
4
.
Slide in the battery tray
4
.
Reattach the cap
2
by aligning the dot on
cap
2
with the one on the bottom of hand-
held unit
11
. Push the cap
2
on until it snaps
in the place.
Mounting the attaching cord
Thread the end of short loop of the attaching
cord
5
through the hole at base of cap
2
(Fig. B).
Insert the opposite part of the end of attaching
cord
5
with the plastic toggle through the
loop. The attaching cord
5
is snug against
the cap
2
.
The large loop is now available to hang on a
peg or over a showerhead or faucet.
The cleaning brush can also stand on its base
for easy and upright storage.
Operation
Select a suitable brush head
6
,
7
,
8
,
9
,
10
based on the type of dirt and the surface
being cleaned.
To change the brush heads, grip lower half of
handheld unit
11
with one hand and brush
head with other hand.
Turn the brush counter-clockwise and pull up
(Fig. C1).
To attach another brush head, hold the hand-
held unit
11
and pull down selected brush
head.
Note: Always set the On / Off button
1
to
position „0“ when changing brush head.
Align the guide lugs of the respective brush
head with the guide rails of the handheld unit