Silvercrest 331449_1907, Руководство по эксплуатации

Страница: 28 / 120

GB
│
IE
│
25 ■ SMAS 500 A1
♦ Remove the container from the base and fill it with milk. Add enough
milk to reach the MIN mark (= 75 ml) inside the container . However,
you should never fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will spill over:
–
up to the lower MAX marking
(= 150 ml), if you want to froth milk
–
up to the upper MAX marking
(= 300 ml), if you only want to heat
the milk
♦ Place the container on the base .
♦ Put the lid on.
♦ Use the function button to select the appropriate programme:
–
Press once = heat milk with stiff froth
–
Press twice = heat milk with creamy froth
–
Press three times = heat milk with only a little froth
–
Press four times = froth milk without heating
The control lamp for the relevant programme lights up (red = hot, blue =
cold). The selected programme starts automatically.
♦ The appliance switches off automatically at the end of the programme, the
control lamp
goes off.
If you want to stop the preparation process before completion, press the
Function button
or remove the appliance from the base . You will
have to reselect the programme when you resume the preparation process.
♦ Remove the lid and pour the milk and/or the milk froth into the desired
container.
♦ Allow the appliance to cool down for about 2 minutes before you froth up
another portion of milk. Otherwise the appliance will automatically trigger the
overheating protection after five successive cycles. The control lamps
flash
and you cannot make any entries. The appliance is ready for use again after
around five minutes.