■
76
│
GB
│
MT
SKR 800 B2
♦
Hold the mounting plate under the installation location. Ensure that the front
edge of the mounting plate is approx. 3.1 cm behind the front of the cup-
board so that the device is connects flush with the cupboard after instal-
lation. The side edges of the mounting plate must spaced approx. 6.3 cm
away from adjacent cabinets or walls.
♦
Mark the 4 mounting points with a pencil.
♦
Using a pin or nail, make a small depression at the respective marking
points.
♦
If required, place the supplied spacers between the cupboard and the
mounting plate. If you are using the spacers, you will need the long mount-
ing screws .
♦
Screw the mounting plate tight using the mounting screws provided ( or ).
♦
With the top of the device against the mounting plate, push the device back
until it clicks into place.
♦
Check to ensure that the device is firmly in position and safely route the
power cable and the wire aerial .
Dismantling
♦
Pull the device forwards off the mounting plate .
♦
Unscrew the screws ( or ) on the mounting plate and remove the
mounting plate from the wall cupboard.
Setting up the device
You can also set up the device on a level surface. So not to cover the ventilation
slots and speakers on the bottom of the device, you must fold out the adjusta-
ble foot of the device:
♦
Reach into the recess on the side of the adjustable foot and pull it out as far
as it will go.
♦
Select a suitable location for the device (also see the section "Set-up location
requirements").
Содержание 279238
Страница 3: ......