Silver Raptor DCZ, Руководство пользователя

Страница: 32 / 134

31 (39)
Useful tip: When wiping the boat’s windshield dry after cleaning, avoid using circular
motions. This can leave circular smudges on the windshield that become visible in sunlight,
impeding visibility. Wipe off any streaks with dry newspaper or cotton cloth using first
horizontal, then vertical motions. Repeat this a few times and you'll bring the windshield to a
brilliant shine.
Care instructions for the stainless steel components
To keep the boat’s stainless steel parts, such as rails, handles and bollards, shining as good as
new, you should keep the parts clean and waxed. The edges of the mounting flanges of the
rails should also be cleaned. Any dirt that remains under the edge of the flange will begin to
look like rust. In regular use (i.e. no damage), the parts should be cleaned and waxed at least
twice every summer. Rail maintenance should also be performed when the boat is put into
winter storage.
Care instructions for the steering system
The hydraulic steering does not require maintenance under normal circumstances. If the
steering starts to feel loose, there is a leak somewhere in the system. Leaks must be repaired
immediately!
WARNING! A hydraulic steering system that has a leak or trapped air in the
hoses is extremely dangerous.
Care instructions for electrical components
Electrical components like main switches, other switches and couplings do not normally
need to be serviced if the boat is stored in a dry and well-ventilated place for the winter. If,
however, you wish to protect electrical components against oxidation, the best way to do it
is by spraying them every now and then with a moisture repellent antioxidant.
Minor superficial repairs
You can repair minor surface damage to the boat’s hull or deck yourself. However, achieving
a neat, unnoticeable repair requires a considerable amount of skill:
1. Protect the area around the damage with tape.
2. Bevel the edges of the damaged area and clean with acetone.
3. If the damage is deeper than 2 mm, it is advisable to smooth it with an appropriate
polyfiller before painting.
4. Mix topcoat with 1.5-2 % hardener.