36948-EN
15
Printed in USA 10/13 © 2013
3-Product Dairy Dispenser
Model SKBD3LS
P
RINCE
C
ASTLE
LLC
W O R L D W I D E
Cleaning the Product Tanks
Turn the power switch to the OFF position.
1
Open the front and top access doors of the unit.
2
Place an empty cup under the dispensing tube.
Catch any remaining product.
3
Open the product valve.
Pull it out slightly and turn it
counterclockwise a quarter of a turn (parallel to the
dispensing tube slot).
Valve Shown in
Closed Position
Valves Shown in
Open Position
4
Repeat Steps 3 & 4 for the other two product tanks.
5
Remove the dispensing tubes from the tank(s) and
discard.
Product Tanks
Dispensing Tubes
(Part No.
37222/
DCP SKU 711490)
6
Soak the tanks and covers.
Place the tanks and
covers in the three compartment sink, filled with a
Dunkin approved dairy dispenser detergent, making
sure to follow manufacturer’s specifications for
detergent use. Let soak for 5 minutes.
7
Clean the tanks and covers.
Thoroughly brush-clean
the tanks and covers. Make sure any film is removed
from internal and external surfaces.
8
Thoroughly rinse the tanks and covers in warm
water.
9
Sanitize the tanks and covers.
Rinse the tanks and
covers in the sanitizing solution for a minimum of one
minute. Remove from sanitizing solution, shake to
remove excess solution and place the parts on a clean,
dry surface to air dry.
10
Sanitize the slots and valves.
With an approved
sanitizing solution, thoroughly clean the dispensing tube
slots and dispensing valves. Allow to air dry.
11
Attach new dispensing tubes.
Using clean gloves,
attach new dispensing tubes (Part No.
37222/
DCP SKU 711490) to the bottom of the product tanks.
12
