MAINTENANCE
Lubrication
Storage
AIR RIVETER
1/4" CAPACITY
PRODUCT INFORMATION:
Page 4
Product Type:
AIR RIVETER - 1/4" CAPACITY
Every three to four hours of operation, lubricate the jaws (#PR14-04) and
the principal axis (#PR14-A09) as necessary.
Use of a thicker oil can lead to adverse performance or malfunction.
If a thicker oil is used by accident, wash it away immediately.
Avoid storing air tools in locations subject to high humidity. If the tool is left
after being used, the residual moisture inside the tool can cause rust.
Before storing and after operation, oil the tool at the air inlet with a good
quality air tool oil and run the tool for several cycles.
Cleaning for the Head of Riveter
Disposal
*In ordering parts and components, give each part number, name and quantity.
Ordering Service Parts
FIG. 1
FIG. 2
Dispose of the worn out tool according to national regulations.
For further operational and handling information or for replacement parts
and components, contact the sales agent from whom you purchased the
tool or the service division of our company.
1. Turn off air supply. Assure all pressure is released prior to disassembly.
2. Use spanner wrench to dismantle the riveter head in FIG. 1.
3. Use spanner wrench to disassemble as shown in FIG. 2.
4. Clean all inner/assembly parts of the riveter head with a brush.
5. Reassemble the inner/assembly parts.
6. Oil the parts and reassemble riveter head completely.
• Powerful, durable, high speed production tool
• Quick release air valve permits cylinder to return
quickly for high speed assembly operations:
Prevents overloading for long life
• Provides quick, quiet and comfortable operation
preventing user fatigue
• Includes the following nosepieces: 1/4"(6.4mm),
3/16"(4.8mm), 5/32"(4mm),1/8"(3.2mm), 3/32"(2.4mm)
Model:
SE1214
www.matcotools.com
1512186-23MA
Adding oil for hydraulic riveter
FIG. 2
FIG. 4
FIG. 5
FIG. 6
FIG. 3
FIG. 1
1. Turn off air supply by disconnecting air hose from rivet gun.
Bleed any air remaining by squeezing the handle several
times.
2.
Use the supplied wrench to dismantle
the #2 outer cylinder
riveter head.
3. Clamp riveter in vice like in FIG.
1.
4. Use wrench supplied to open the cover located on the bottom
of the rivet gun as in FIG.
2
.
5.
Remove piston from cylinder as FIG. 3 illustrates.
6. Clean the inside of the cylinder, clean the piston stem
and lubricate the o ring cover seal as in FIG. 4
7. Lubricate the intake with a good quality hydraulic oil,
(fill only to the top of the center intake tube) as shown in
FIG. 5 add a light coat of grease to the inner cylinder wall.
8.
Reassemble as in FIG. 6.
