Silver Stream-In / Stream-Out - User Manual SR 1.0.4 – 10/2012
Page 39
Whiterock Business Park - 729 Springfield Road - Belfast BT12 7FP - Northern Ireland
Tel.: +44 28 9067 7200 | Fax: +44 28 9067 7201 | www.aptcodecs.com | [email protected]
3.1.2
Front panel Components
Figure 3-1: Silver Stream-In/Stream-Out front panel components
3.1.2.1
Monitoring
(1) The 6.3mm jack socket is provided for audio monitoring with a headset or active monitor
speaker. Depending on the type of Silver unit it is either the audio input (Stream-In) or the
audio output (Stream-Out). This monitor output has a fixed signal level and is not adjusta-
ble.
3.1.2.2
Power- Connection - and Alarm Status
(2) The blue Power indicator LED indicates that power is applied to the unit
The red Alarm indicator LED indicates that an alarm condition exists. There are a number of
alarm conditions which can be enabled on the Silver range.
The “Connected” LED shows the presence of a connection. The following table shows the dif-
ferent states of the LED.
Connected LED Color:
Off/Grey
Green
Red
No Stream enabled
X
Receiving & Transmitting ok
X
Connection Error
X
3.1.2.3
Reset Switch – Default IP Addresses
(2) Between the “Connected” and the “Power” LED there is a small hole in the front panel.
Behind this hole sits the IP Address Reset Switch. To change the IP Address of the Silver
units to the default addresses, insert a small tool until and press the switch. Hold it in place
until the Connected LEDs start to flash (about 5 seconds) – then remove it.
The unit will then have changed IP address; it does not need to reboot. It will take a short
while (~10sec) until the Web GUI will be accessible again on the default addresses.
The default IP address of the ETH is:
192.168.100.110
