Silver Stream-In / Stream-Out - User Manual SR 1.0.4 – 10/2012
Page 22
Whiterock Business Park - 729 Springfield Road - Belfast BT12 7FP - Northern Ireland
Tel.: +44 28 9067 7200 | Fax: +44 28 9067 7201 | www.aptcodecs.com | [email protected]
2.7.3
The Net Wizard
The third button starts the Net Wizard, which scans a user defined IP address range in order
to auto-detect any reachable WorldNet/WorldCast Codecs on the network. Click on “Net Wiz-
ard” to start the network scan. Run the Net Wizard for the auto-detection of any Codec on
the network.
The Net Wizard provides automatic detection of each device connected to the network by its
corresponding IP address. The Net Wizard scans an IP address range and reports the detect-
ed unit. You may choose whether to add all or a selection of the detected frames to the Main
Screen. Click on “Net Wizard” and follow the Wizard’s instructions.
Figure 2-9: Shows results from a network scan of range IP: 192.168.115.1 onwards. The scan was
stopped manually at xxx.xxx.xxx.116 (no further units expected).
Begin by entering an IP address you wish to start searching from; then click on “Begin
Scan”. The Net Wizard will scan all IP addresses from the one entered, ending when the last
number in the search address reaches 255. You can stop the search at any stage by clicking
on “Stop Scan”.
Whenever the Net Wizard finds Codec devices it will display them in a list on the right hand
side of the screen.
To add a unit to the family tree, double click on the chosen entry in the list or to add all of
them click on “Add All”.
If the Net Wizard has not found any connected units, you should double check the network
settings on the Net Wizard. The Wizard scans the IP address range from the IP address you
enter incrementing the last number until it reaches 255.
