CONTROLS
On/Off power switch. The pump is fitted with an automatic electric pressure sensing switch which automatically starts the pump
when the pressure falls below a preset pressure, and stops the pump when the pressure reaches a maximum preset pressure. (Some
models are fitted with an adjustable pressure regulator).
DIMENSIONS
100 LITRE
200 LITRE
300 LITRE
400 LITRE
Length
660
mm
1050
mm 1010mm
1010mm
Width
590
mm
590
mm
940mm
940mm
Height
580
mm
535
mm
500mm
670mm
Weight
(dry)
13
kg
18
kg
27kg
31kg
To calculate the weight of the sprayer add 1kg to the dry weight for every litre of water. E.g. The laden weight of the sprayer with
16L of water is 21kg
SETTING UP YOUR SPRAYER
Where using the PA Spray Gun Fit the extension lance to the handgun ensuring the nylon washer is fitted between them. Fit the
hose to the gun, using the hose clip supplied. Fit the white elbow fitting to the other end of the hose and secure it with the hose
clamp provided. Placing the hose in hot water may assist at this stage. Fit the hose to the outlet side of the pump.
CONNECTING TO 12 VOLT DC SUPPLY
The Sprayer requires a 12 volt DC power source. A 3 metre loom is provided with the sprayer to allow the sprayer to be
connected to the 12 volt DC source available. The red wire is positive and the black is negative. If you extend the wire use wire
of the same guage or larger.
An on/off switch is fitted to the sprayer to allow the sprayer to be switched off from the 12 volt DC source to prevent accidental
drain of power. The switch also allows the pump to be shut down when the tank is empty preventing overheating and damage to
the pump.
•
Important Note!
Ensure that distance from the power supply to pump is minimised.
•
Important Note!
If extending power cables ensure a cable of equal or preferably greater current capacity is used
as over extended wires may overheat, blow fuses or damage the pump
•
Important Note!
Consult your vehicle instruction manual for correct electrical connection.
FITTING INSTRUCTIONS
Position the sprayer so as to minimise contamination to the operator. With the pump away from operator the risk of
contamination due to hose failure can be minimised. It is recommended that the sprayer be securely attached to the vehicle
or trailer. Refer to manufacturer’s instructions for appropriate load limits and fitting positions.
Note : 1 litre of water = 1 kg.
Never fill spray tank to a capacity beyond the specified overall weight limits set by your vehicle manufacturer. Recesses in
the top of the tank allow for tie down straps. When fitted these should be firmly secured to approved attachment points on
the ATV or other vehicle.
The sprayer should be mounted centrally and as near to the vehicle centre of gravity, as possible. It should not protrude so
as to cause an obstruction.
Installation
Specifications
SPRAY GUN
A variety of spray guns are fitted and matched to the pump for optimal spraying
•
The PA spray gun is fitted with 500mm extension and fan nozzle is a
professional choice and popular for spot spraying.
•
The Triam 49 Spray Gun is ideal for atomised spraying and is only fitted
to spray units with pumps capable of more than 150psi
•
The Spotjet spray Gun is for general duties spraying suited, with 600mm
extension and adjustable nozzle
