Silvan Selecta Oktopus 500L, Руководство оператора

Страница: 15 / 18

1
Calibration
3. Berries
Application rate 400 l/ha
Travel speed 5 km/hr
Row width 3 m
Spraying pressure 13 Bar
If using 8 nozzles (4/side) with two turned off due to a smaller canopy then each nozzle needs
to deliver 1.25 l/min. From the HCC nozzle chart HCC015 (Yellow) at 13 Bar pressure will give
the desired output. An alternative nozzle would be the HCC02 at approximately 7 Bar to give an
equivalent output.
Calibration Worksheets
The worksheets below can be used to record the results of calibration tests on your sprayer.
Total Application Rate (l/min) = Application rate (l/ha) x Speed (km/hr) x Row width (m)
600
400 x 5 x 3
600
= 10
l/min
Date of Test: _______________
Application Rate: _______________ litres/ha
Speed of Travel: _______________ km/hr
Row Spacing: _______________ metres
No. of nozzles : _________
Output per nozzle : _________ litres/min
Nozzle Selection : __________
Pressure Setting: __________ Bar
Measured Output: _________ litres/min
(from test run)
Output (l/min)
=
Application Rate x Speed x Row Width
600
x x
600
=
=
litres/min
Date of Test: _______________
Application Rate: _______________ litres/ha
Speed of Travel: _______________ km/hr
Row Spacing: _______________ metres
No. of nozzles : _________
Output per nozzle : _________ litres/min
Nozzle Selection : __________
Pressure Setting: __________ Bar
Measured Output: _________ litres/min
(from test run)
Output (l/min)
=
Application Rate x Speed x Row Width
600
x x
600
=
=
litres/min