11
EN
EN
7.2 Treatment steps
1. Make sure your skin is clean, dry and free from powder, cream or gel.
2. Make sure that the
rubber cap
(#2),
filter
(#3), and
treatment tip
(#1) are
fi
rmly in place. For your
fi
rst few treatments, be sure to use the
Fine
treatment tip
.
3. Press the
control button
(#4) to turn on the device. Your Silk’n Reveal is
ready for use in low suction mode.
4. Apply the
treatment tip
fi
rmly to your skin so that you feel the suction.
5. Work each area as recommended in section “6.1 Treatment areas”.
6. To move from low to high suction mode, press the
control button
again.
7. To switch o
ff
the device after treatment, short press the
control button
once or twice, depending on which suction mode you are in.
8. Unplug the device and store it in its original box. Please refer to section
“8. Maintenance”.
7.3 After treatment
Try not to expose recently treated areas of skin to sunlight. Be sure to
apply sunscreen SPF 30 or higher when out in the sun.
You may wish to apply a facial mask, or apply a day or night cream.
8. Maintenance
It is important to clean your Silk’n Reveal device and store it properly after each
treatment.
L
First, unplug the device.
L
To clean the device, wipe with a clean, dry cloth. Never use
acetone or other abrasive
fl
uids, because they will damage
your device.
Revit Reveal UM NA 2289A inside ED98-07 release.indd 11
1/19/2017 11:46:14
