11.6 KC - South Korea
The MGM210P22A low-power variants have a RF certification for import and use in South Korea. Their certification number is R-C-
BGT-GM210P.
When integrating the RF-certified module, an end-product is exempted from doing the RF emission testing as long as the recommen-
ded design guidance is followed, and the approved antennas are used.
EMC testing, and any other relevant tests, might still be required for full compliance.
11.7 Proximity to Human Body
When using the module in an application where the radio is located close to the human body, the human RF exposure must be evalu-
ated. FCC, ISED, and CE all have different standards for evaluating the RF exposure, and because of this, each standard requires a
different minimum separation distance between the module and human body. Certification of MGM210P allows for the minimum sepa-
ration distances detailed in the table below in Portable use cases (less than 20 cm from human body). The module is approved for the
Mobile use case (more than 20 cm) without any need for RF exposure evaluation.
Table 11.2. Minimum Separation Distances for SAR Evaluation Exemption
Certification
MGM210P22A
MGM210P32A
FCC
Bluetooth: 5.3 mm, Zigbee: 5 mm
Bluetooth: 44.03 mm, Zigbee: 36.17 mm
ISED
Bluetooth: 20 mm, Zigbee: 15 mm
Bluetooth: 40 mm, Zigbee: 35 mm
CE
The RF exposure must always be evaluated using the end-product when transmitting with power levels high-
er than 20 mW (13 dBm).
For FCC and ISED, using the module in end-products where the separation distance from the human body is smaller than that listed
above is allowed but requires evaluation of the RF exposure in the final assembly and applying for a
Class 2 Permissive Change
or
Change of ID
to be applied to the existing FCC/ISED approvals of the module. For CE, RF exposure must be evaluated using the end-
product in all cases when transmitting at more than the power level indicated in the table.
Note:
Placing the module in touch or very close to the human body will have a negative impact on the efficiency of the antenna thus a
reduced range is to be expected.
11.8 Bluetooth Qualification
The MGM210P modules come at launch with a pre-qualified Bluetooth Low Energy RF-PHY Tested Component having Declaration ID
of D043475 and QDID of 129390, and having a listing date of 2019-04-02.
Because the validity set by the SIG for Tested Components is currently of 3 years, during the product lifetime Silicon Labs will renew
this Component as it expires, whenever applicable. Renewed Tested Components will come with new DIDs and QDIDs, and these will
be then referred to in end-product listings. Such new DIDs and QDIDs can be discovered starting from the original ones.
This module’s RF-PHY Tested Component should be combined with the latest Wireless Gecko Link Layer and Host pre-qualified Com-
ponents by Silicon Labs, when in the process of qualifying an end-product embedding the MGM210P via the SIG’s Launch Studio.
MGM210P Wireless Gecko Multi-Protocol Module Data Sheet
Certifications
silabs.com
| Building a more connected world.
Rev. 1.2 | 47