Silicon Graphics Reality Center, Руководство по установке

Страница: 31 / 117

Projector Set Up
6-2 R5976280 RC3300W 19072001
Projector Address
Projector Address Setting
The projector's address may be set to any value between 0 and 255. Each projector needs a separate address.
When the address is set, the projector can be controlled now by :
- RCU for addresses between 0 and 9.
- a computer for addresses between 0 and 255.
Address Set Up
The set up of an address is a hardware SETUP of the projector which must be done during installation.
Use the 8 DIP switches provided on the controller board labelled 'Projector Address'.
Each DIP switch has its own decimal value. The sum of the values associated to those DIP switches gives the address.
See table below for the equivalent value. If Switch No. 1 is set to ON, it represents a decimal value of 128, Switch No.2 for 64, Switch
No.3 for 32, and so forth.
In the given example, the projector address is set to 202 :
DIP switch No. : 1 2 3 4 5 6 7 8
Position ON/OFF : 1 1 0 0 1 0 1 0
Sum : 1x128 + 1x64 + 0x32 + 0x16 + 1x8 + 0x4 + 1x2 + 0x1 = 202
Table :
Standard set up for a RC-3300W system.
Left projector : address 1
Middle projector : address 2
Right projector : address 3
If a second system is installed in the same room, these projector addresses should be higher than 3, e.g. 4, 5 and 6.
Switch No Value
1 128
2 64
3 32
4 16
5 8
6 4
7 2
8 1
OFF ON
3URMHFWRUDGGUHVVHV