Silicon Graphics Rackable C1104G-RP5, Руководство пользователя

Страница: 15 / 76

007-5839-001 1
Chapter 1
1. Introduction
Important: SGI Rackable server systems may sometimes require driver versions that are not
included in the original operating system release. When required, SGI provides these drivers on
an SGI Driver CD, which may ship with the system, or on the system disk (pre-installed in the
factory). For more information on this topic check with your sales or service representative.
The Rackable C1104G-RP5 server is a 1U rackmount system (see Figure 1-1 on page 2 )
.
In addition to the serverboard and chassis, various hardware components may be included with
the system, as listed:
• Ten 4-cm chassis fans
• One internal air shroud
• Two passive 1U CPU heatsinks
• Riser cards as follows:
– One riser for a single PCIe x16 card, (left-front side internal GPU card)
– One riser for a single PCIe x16 card, (left-back side internal GPU card)
– One riser for a single PCIe x16 card, (right-front side internal GPU card)
– One riser for one low-profile PCIe 3.0 x8 card (external-facing rear card)
• Three power cables for GPU cards
• SATA accessories:
– One SAS/SATA backplane
– Four hot-swap disk drive carriers (RAID must be enabled for hot swap)
• Two power supplies
• One rackmount kit