Silicon Graphics InfiniteStorage 120, Руководство пользователя, Страница: 30 / 42

InfiniteStorage 120 Hardware Topics . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
22
Removing the Components from the Drive Module
Removing the components from the drive module makes the module lighter and easier to
lift into the cabinet. Use the following procedure to remove the disk drives, power-fan
canisters, and ESMs from the drive module. Place the components on a dry, level, static-
free surface.
Before beginning this task, see “Tools and Equipment” on page 17 for a list of the tools
that will be helpful in performing this procedure.
W
ARNING (W09) Risk of bodily injury –
Three persons are required to safely lift the component.
A fully-populated drive module can weigh up to 40.8 kg (90 lb). Do not attempt to install
the drive module in the cabinet unless you remove all of the components. The weight of
the module with all of the components removed is approximately 15.9 kg (35 lb).
C
AUTION Possible hardware damage – To prevent electrostatic discharge damage to
the module, use proper antistatic protection when handling module
components.
1
Put on antistatic protection.
2
Remove the disk drives from the drive module. Figure 18 shows how to remove a
disk drive.
a
Pull the drive handle to the left.
b
Use the handle to pull the disk drive out of the slot.
c
Put the disk drive on an antistatic, cushioned surface away from magnetic fields.
d
Repeat steps 2a through 2c to remove all remaining disk drives.
e
Although it is not required, you can also remove the blank drive components, if
any exist.