10
Air Conditioner Operating Instructions
(cont’d)
4) Press the FAN key to select the desired fan
speed setting (Auto-Low-Med-High). Your
selection will appear in the display window
(each depression of the fan key will advance
to a different setting).
5) Press the SWING key to activate the automatic
air swing (oscillating) feature (the “ ”
symbol will appear in the display window).
To deactivate the air swing feature, press the
SWING key again.
6) The horizontal louvers open and close
automatically when the unit is switched on
and off. To adjust “air flow” direction, (up / down
only) adjust the center louver only up or down.
The blue indicator light will come on indicating the
air-conditioning mode is operational (there may be a
slight delay of 10-30 seconds before the cycle
begins, this is normal).
Cooling stops automatically when the set
temperature is achieved. Cooling resumes when the
room temperature rises above the set temperature
level. The temperature has no effect on the fan
operation. Therefore, the fan will operate
continuously (after the compressor has cycled off) to
maintain optimal temperature control.
Fig. 16
CAUTION
During air conditioning and dehumidifying modes, if the
compressor cycle is interupted (unplugged, power
failure,etc.) and reinstated immediately thereafter, (within
3-5 minutes) a “compressor protection circuit” is
automatically self-activated. The compressor cannot
operate during a “compressor protecton” condition. (this is
normal) It may take 3-5 minutes before the “protection
circuit” self-deactivates.
DO NOT ATTEMPT TO START THE UNIT
(COMPRESSOR) DURING THIS PERIOD.
Upon re-starting the unit (turn 1/0 switch on) all
program information(i.e. time, mode, fan speed, auto
timed programs) will have to be re-set.
ATTENTION
Removal and/or displacement of the internal water
tank will cause the compressor to stop operating
(this is a safety feature). This condition will cause
the unit to beep (20 seconds) and the “water full”
(red) light will illuminate continuously until
corrected. The compressor cannot operate
during a “red” light condition.
Check the following;
1. Is the internal water tank full?
Empty and re-install water tank.
2. Has the water tank been accidently displaced?
Re-position water tank.
The “red” light will turn off automatically when the
water tank has been emptied and/or re-positioned.
I/O
MODE
FAN
SWI
NG
RUN
