Silex technology SX-550, Руководство разработчика

Страница: 30 / 123

3. Right-click on the SX-550 that you want to
configure from the displayed list, and then left-
click on
Configuration . The default SX-550
name is SDS xxxxxx (where xxxxxx is the last
six digits of the MAC address from the label
that is affixed to the SX-550).
4. If you do not have a DHCP server, you will be
asked to manually enter an IP address (if you
are not sure what IP address to enter, ask
your network administrator). Click
OK when
you are finished.
5. The Server Configuration window will appear.
Check the IP address setting to make sure it
is correct. If necessary, change the Subnet
Mask and Gateway. If you have a WINS
server, enter its address or click
Use DHCP
to Locate WINS Server. If desired, you can
configure advanced TCP/IP settings by
clicking the
Advanced TCP/IP button (refer to
Chapter 6 for information). This advanced
configuration can be done at a later time,
however.
Part Number 40183-101 Silex SX-550 Developer's Guide Page 22
NOTE: If you are using DHCP on your network, the SX-550
should have acquired valid IP settings at this point and no
further configuration is necessary. However, for some
installations, a static IP address is preferred. If your
DHCP server does not allow the SX-550 to keep its
assigned IP address permanently, then you must
manually assign an IP address. In this case, use a static
IP address outside the range reserved for DHCP (see your
DHCP server documentation for details). To assign a
static IP address, select
Set Permanent as the IP Address
Resolution , and assign a valid static IP address for your
network. Click on OK to save the new settings.