IM_FULL_55SL_REV_B
9
WHITE / BLACK WIRE – NEGATIVE SAFETY SHUT DOWN INPUT & HOOD TRIGGER
The
White Black
provides an instant
shutdown for the remote start,
whenever it is grounded. Connect the
wire to the hood pin switch previously
installed. This wire must be routed
through a grommet in the firewall and
connected to the hood pin switch. If the
pin switch is to be used with an alarm
system, connect this wire with diode.
Important!
This connection is a safety wire and must be connected as shown and tested as specified. Failure to do so
may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be used
if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for ground switched
brake light circuits and must be connected to the output of the brake switch.
YELLOW WIRE – (-) 200MA IGNITION 3 OUTPUT –
This wire provides a 200mA (-) ground output that becomes active 2 seconds before the
remote start unit initializes, and remains grounded while running.
Ignition 3 output:
Some newer vehicles use a third
ignition wire which is required to start
and keep the vehicle’s engine running.
If this is the case, wire an IGN 3
relay (not supplied) as shown: Do not
connect any vehicle circuits together,
they are isolated for a reason.
Yellow Wire
87a
Ignition 3 Wire From
Ignition Key Switch
+ 12 V Constant
Fused 25A Capable
30
85
86
87
TRANSPONDER INTERFACING USING RELAY AND YELLOW WIRE:
If the vehicle has a transponder system installed, you will need to by-pass the system while
the vehicle is operating under the control of the Remote Start Unit.
To do this:
1. You will need a transponder key that’s already programmed to the vehicle.
2. Remove the trim around the ignition switch.
3. Wrap a thin (28 - 30awg) wire tightly around ignition switch 6 to 8 times and secure it.
4. About 6” down line make another loop of approximately 2” diameter.
5. Place the key inside this loop and secure it to the loop.
1. Connect an end of the (28 - 30awg) wire to pin (87) of the relay module.
2. Connect the other end of the loop wire to Pin (30) of relay module.
3. Connect the pin (86) of the relay module to the ignition wire from the ignition switch.
4. Connect the pin (85) of the relay module to the yellow wire of 20-pin connector.
To: White/black wire /
Negative safety
To: Alarm instant
trigger
Blue
wire
Hood Pin Switch
Diode
Diode
