Silencer 50SL, Руководство по установке

Страница: 8 / 20

IM_FULL_50SL_REV-A
8
10 PIN ACCESSORY CONNECTOR
WHITE / BLUE WIRE – (-) INSTANT START & TURN OFF INPUT –
This wire activates and turns off the remote starter each time it sees a momentary ground signal.
Normally used for testing during installation or when activating the module from an after-market system.
WHITE / BLACK WIRE – NEGATIVE SAFETY SHUT DOWN INPUT & HOOD TRIGGER
The White Black provides an instant
shutdown for the remote start,
whenever it is grounded. Connect
the wire to the hood pin switch
previously installed. This wire must
be routed though a grommet in the
firewall and connected to the hood
pin switch. If the pin switch is to be
used with an alarm system, connect
this wire with diode.
To: White/black wire /
Negative safety
To: Alarm instant
trigger
Blue wire
Hood Pin Switch
Diode Diode
Important! This connection is a safety wire and must be connected as shown and tested as specified. Failure to do so
may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be used
if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for ground switched
brake light circuits and must be connected to the output of the brake switch.
BLACK/WHITE WIRE – (-) NEUTRAL SAFETY SWITCH INPUT OR (-) ENABLE SWITCH INPUT –
1. When the BLACK/WHITE wire is grounded, the remote start unit is operable. When this wire is open from ground,
the remote start is disabled.
2. The optional “remote start toggle switch” can be added on to temporarily disable the Remote Start Device, it can
prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or
stored in an enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the
“OFF” position. To enable the remote start, move the optional remote start enable toggle switch to the “ON” position.
3. If needed, this wire can be connect to the PARK/NEUTRAL switch in the vehicle.
(See the TESTING YOUR INSTALLATION GUIDE)
IMPORTANT NOTE: This wire must have a “GROUND” to operate remote start.
WHITE / VIOLET WIRE – POSITIVE SAFETY SHUT DOWN INPUT – MUST BE INSTALLED
This wire provides an instant shut
down for the remote start, whenever
it gets +12volts. If the brake lights
switch in the vehicle sw12
volts to the brake light circuit, connect
this wire to the output side of the
brake switch. This will allow the
remote start to shut down if an
attempt is made to operate the
vehicle without the key while running
under the control of the remote start.
In most vehicles, in order to shift gear,
the brake pedal must be depressed.
The brake input will in turn cause
the remote start unit to shut off.
See diagram.
+12 volts from fuse box
To White/Violet
wire
Brake light bulbs
Switch closes
When brake is
depress