Silca Unocode 299, Руководство по эксплуатации

Страница: 51 / 67

Operating manual - English UNOCODE 299
Copyright Silca 2002 47
7.5 C
HECKING AND
/
OR REPLACING FUSES
Fuses should be checked with a tester (ohmmeter, multimeter, etc.) as they may appear to be in good
condition even when they are electrically faulty. Fuses must always be replaced with the same amperage
and type (rapid or delayed), as indicated in this manual.
There are 6 fuses in the UNOCODE 299.
• 2 fuses: 4 Amps rapid
located next to the power socket on the back of the
machine, next to the main switch (fig. 37). These
fuses protect the machine from power surges and/or
spikes in the electricity supply.
To check and/or replace the fuses proceed as follows:
1) turn the machine off and unplug it from its power
supply cable.
2) use a flat screwdriver to open the flap covering the
socket, remove and check the fuses, replacing
them if necessary.
Fig. 37
• 4 fuses: F1, F2, F3, F4
F1: 10 Amps delayed
- protects the cutter motor and its electronic controls
F2: 6,3 Amps delayed
- protects the step motors and their electronic controls (+32V d.c.)
F3: 4 Amps delayed
- protects the logic control circuits on the microprocessor board (+5V d.c.)
F4: 2 Amps delayed
- protects the digital output circuits for the low voltage controls and the sensor inlets (+24V d.c.)
Situated on the electronic circuit board inside the base of the machine (fig. 38) protecting the board from
short circuits.
To check and/or replace the fuses proceed as follows:
1) turn the machine off and unplug it from its power supply cable.
2) remove the bottom panel (ch.7.9, page 50).
3) check and, if necessary, replace the fuses in the way described below:
to remove the fuse:
- press the fuse cap with your fingers and turn it counter clockwise.
To fit the new fuse:
- carefully position the fuse back into place, then gently press the fuse cap downwards turning it clock-
wise.
Fig. 38
F2
F3
F1
F4
to open fuse cap
to close fuse cap
electronic circuit board