Silca Unocode 299, Руководство по эксплуатации

Страница: 26 / 67

UNOCODE 299 Operating manual - English
22 Copyright Silca 2002
• Types of cut
All the data cards provided by Silca have the type of cut pre-set according to the original parameters.
The types of cut possible with UNOCODE 299 are: Normal, Flat, Laser and Vertical.
N
ORMAL
For conventional car and door keys.
F
LAT
Mainly used for car keys where the cut edges are
rounded to facilitate the movement of the blades when
the key is put into the lock.
L
ASER
Conjunction of the cutting angles is determined
automatically by the machine, allowing cuts to be made
with variable angles; this facilitates the smooth entry of
the key into the lock, prolonging the working life of the
key.
V
ERTICAL
Necessary for special keys with small bits (Silca art. FO19P,
FO21P...) where a special cutter is required.
When this cutting method is used a special angled cutter
is needed.
E
XAMPLE OF HOW TO CHANGE THE TYPE OF
C
UT
:
All the technical data regarding the types of
cuts stored in the machine’s memory can be
changed according to the user’s requirements.
1) enter data card number (e.g.: nr.50)
2) before entering the cuts press the
combination of keys SHIFT+ENTER.
3) enter the “L” type cut by pressing the
SHIFT+L keys to set the laser type cut.
- the letter in brackets (L) indicates the
type of cut recommended by Silca.
NOTE:
for certain cutting methods the standard
cutter U01 must be replaced with a
specific cutter
(Ch.4.6 "Changing the
cutter", page 16).
4) enter the combination and proceed with the
operations described in ch.5.2, page 19.
N
P
L
V
V
Enter card number
STANDARD = 50
USER = 0
(ver. DB : 1)
Side 1 x 2 S. 50
. . . . . . .
Possible depths:
1234
S. 50
Cutter: U01
Cut type (L) = L
Alternative : N P
Side 1 x 2 S. 50
112233
Possible depths:
1234
ENTER
ENTER
ENTER
+
SHIFT