Silca Twister 2, Руководство по эксплуатации

Страница: 17 / 26

Operating manual - English Twister II
Copyright Silca S.p.A. 2017
13
6.2 CALIBRATION OF CUTTER AND TRACER
Note: the TWISTER II key-cutting machine is equipped with a spring mechanism which allows precise
duplication of dimple keys. The spring system is to be used only for dimple keys (chap.7.4) and is
activated by rotating the ring nut (O).
Once the appropriate cutter and tracer have been installed, place two identical key blanks into the clamps and
proceed as follows:
1) Loosen the upper ring nut (O).
2) Loosen the bigger middle ring nut’s locking knob (H2).
3) Turn the bigger middle ring nut (N) clockwise a few turns to lower the tracer.
4) With the (I) lever lower the vertical carriage until the tracer point touches the top of the key in the left side clamp
(Fig. 12).
5) Keeping the (I) lever downwards, turn the bigger middle ring nut (N) counter-clockwise until the cutter touches the
top of the key in the right side clamp (Fig. 13).
6) Lock the bigger middle ring nut’s locking knob (H2).
7) Turn the upper ring nut (O) clockwise up until it is tight to cut laser (sidewinder) type keys.
O
I
N
H2
Fig. 11
Fig. 12
Fig. 13