Silca Twister 2, Руководство по эксплуатации

Страница: 19 / 26

Operating manual - English Twister II
Copyright Silca S.p.A. 2017
15
7.3 CUTTING KEYS WITHOUT KEY STOPS
1) Insert the tip stop bar into the appropriate slots on the clamp and load the key into the jaw so that the tip of the
key rests against the tip stop bar.
2) Adjust the machine according to chap. 6.2.
3) Cut the key according to chap.7.1.
Cutting the edge
If cuts are to be made on the edge, place the key in a vertical position.
Fig. 16
7.4 INSERTING THE SPRING SYSTEM FOR DIMPLE KEYS
The TWISTER II key-cutting machine is equipped with a spring mechanism which allows precise duplication of
dimple keys. Using this system, it is possible to position the tracer into the groove of the sample fi rst and then
proceed with cutting the key. The spring system is to be used only for dimple keys (Fig. 1) and is activated by
rotating the ring nut (O).
Note:for laser type keys (Fig. 1) deactivate this function.
7.5 CUTTING LASER (SIDEWINDER ) TYPE KEYS
NOTE: before attempting to cut laser (sidewinder) type keys, deactivate the spring system for dimple
keys using knob (O) (chap.7.4).
1) Start the cutting operation by activating switch (Q).
2) Lower the spindle and rest the tracer point on a cut part of the original key, cut the key and stop atthe beginning
of the cut.
• secure the spindle at this height by means of knob (R).
• carry out the cuts using only the left-hand lever (C).
Fig. 17