Silca REKORD, Руководство по эксплуатации

Страница: 18 / 35

REKORD Operating manual - English
16 Copyright Silca 2 007
7
KEY CUTTING
ATTENTION: for complete safety during the cutting operations, take the following precautions:
- Always work with dry hands.
- Check that the machine is properly earthed.
- Wear protective goggles even if the machine has a protective shield over the cutting tool.
- Start the motor (switch N) only after completing the operations on the carriage (securing the
keys, etc.).
- Keep hands away from the cutting tool in motion.
7.1
Key cutting
1) Turn the clamps to find the appropriate side for securing the key (fig. -B).
2) Loosen the knobs (F) by a couple of turns (fig. -A).
3) Raise the lower part of the clamps and turn to the required position:
-
Side A of the clamp:
for keys to be fitted on their backs (fig. -B)
-
Side B of the clamp:
for keys placed on their backs and having cuts with a depth of less than 3,9
mm (fig. -B))
-
Side C and D of the clamp:
for keys to be cut on both sides and locked on the groove (fig. -B)
Securing the keys in the jaws
1) Position the original key (left-hand jaw) and key blank (right-hand jaw), ensuring that:
a) the keys are positioned and secured in the clamp;
b) the key stop is resting against the calibration tabs (H);
2) secure the keys by closing the clamps with the knobs (F). 
Fig. 13
D
A
B
C
F
H
A B
A
SOFER Version
D
A
B
C
B
F
H