Silca Quattrocode, Руководство по эксплуатации

Страница: 31 / 59

QUATTROCODE Operating manual - English
Copyright Silca 1999 31
7.3 Motor tests
WARNING: tests for the step motors (X - Y- Z- A ...) consist of checking their electrical operation. The
tests do not check the end of runs (sensors and photocells), so that the motors can run up
to the mechanical stops.
The motors should therefore be tested in both directions without reaching the mechanical stops, as
this would risk straining the machine.
Test 301: X axis motor (lateral carriage)
- - With the motor off the display will show:
<TEST 301>
Hold down the key (right-hand arrow) or (left-hand arrow) to move the motor in the
two directions.
When the key is released the motor stops immediately
If the motor will not start, contact Silca After-Sales Service.
WARNING: if the motor reaches end of run, stop it immediately to avoid unnecessary strain on the
structure.
Test 302: Y axis motor (front carriage)
- With the motor off the display will show:
<TEST 302>
Hold down the key (right-hand arrow - towards the operator) or (left-hand arrow -
towards the machine) to move the motor in the two directions.
When the key is released the motor stops immediately
If the motor will not start, contact Silca After-Sales Service.
WARNING: if the motor reaches end of run, stop it immediately to avoid unnecessary strain on the
structure.
Test 303: Z axis motor (vertical carriage)
- With the motor off the display will show:
<TEST 303>
Hold down the key (right-hand arrow - upwards) or (left-hand arrow - downwards) to
move the motor in the two directions.
When the key is released the motor stops immediately
If the motor will not start, contact Silca After-Sales Service.
WARNING: if the motor reaches end of run, stop it immediately to avoid unnecessary strain on the
structure.
WARNING: if one of the cutting tools is fitted into the spindle, moving the carriage down may cause
the tool to bump into the clamp!
Test 304: A axis motor (spindle)
(make sure that a cutting tool is installed).
- With the motor off the display will show:
<TEST 304>
Hold down the key (right-hand arrow) or (left-hand arrow) to start the motor turning
clockwise or anticlockwise.
When the key is released the motor stops immediately
If the motor will not start, contact Silca After-Sales Service.
WARNING: if the motor reaches end of run, stop it immediately to avoid unnecessary strain on the
structure.