Silca Crown D422143XA, Руководство по эксплуатации, Страница: 27 / 29

Operating manual - English CROWN
Copyright Silca 2001 23
10.5 T17 Synchronised device
1) Install the T17 device on a CROWN key-cutting machine and secure with the knob (M).
2) tighten the knob (K1) on the T17 device, first ensuring that the key-locking grub screws (T) and (T1)
are aligned with the holes on the device.
Fig. 19
Fitting a key:
1) Place the sample key into its seat on the right-hand cylinder of the device, as shown in figura 20 and
push up to the stop (N).
2) turn the key 45˚ anticlockwise, pull towards the operator up to the stop (J) and secure with the grub
screw (T) (fig. 21).
WARNING: before placing the key to be cut into the left-hand seat on the device, check that when the sample
key is taken up to the tracer point this enters the first cut freely.
If not (the tracer point meets obstacles), proceed as follows:
1) loosen the grub screw (T), keeping the key firmly against the tracer point (without excessive pres-
sure).
2) turn the key clockwise slightly (fig. 21) until the tracer point can enter the cut completely.
3) tighten the grub screw (T).
4) fit the key to be cut into the left-hand seat on the device, repeating the operations described above
for the sample key. Secure the key with the grub screw (T1) then proceed with cutting.
Cutting:
5) release the knob (K1) (fig. 22) and push on the head of the key to be cut to turn it clockwise until it
clicks into place for the next cut. Continue in this way for all the cuts.
Fig. 20
K1
N
T
T1
M
N
T