Silca Crown D422143XA, Руководство по эксплуатации, Страница: 26 / 29

CROWN Operating manual - English
22 Copyright Silca 2001
10.4 T14 synchronised device for cutting 5VP3 keys
1) Install the tracer point provided with the T14 device and gauge with the cutter. The tracer point has
a bushing (B2) which must be removed if a ø 3 mm cutter is used.
2) fit the ring (Y) onto the cutter, hold it against the cutter support and secure with the grub screw (Y1).
In this way the setting is maintained when the cutter is replaced.
3) replace the ø 6 mm cutter with the ø 3 mm cutter (provided with the T14), gauge the depth with the
tracer point and fit the ring (Y) to maintain the setting (as described above).
4) remove the bushing (B2) by turning it anticlockwise.
5) install the T14 device on the machine.
6) fit the keys (original and key blank) in front of the tracer point and cutter respectively, push the bit
against the stop (N) and secure the keys with the grub screws (T) and (T1).
7) Cutting positions 1 - 2 - 4 - 5 - 6 - 8
Move the shim (E1) completely to the right and secure the device in this position with the knob (M). Push
the head of the key to turn it clockwise until it clicks into the position mentioned. Secure in position with
the knob (K1) and cut.
8) Cutting positions 3 - 7
Move the shim (E1) completely to the left and repeat the same operations described above at point 7.
Fig. 18
3,3
mm
T
B2
Y
Y1
E1
right left
M
K1
0,6 mm