silavent Green Line HRX2 Series, Инструкция по установке и эксплуатации

Страница: 9 / 25

LAB939R, Issue 2, July 2014 Page 9
2.3 Installing the frost protection sensor (HRX2-FP, HRX2-BFP)
2.3.1 Important: This operation should only take place after the left or right-handed position of the
appliance has been determined.
2.3.2 Referring to the diagram at 2.2.8;
2.3.3 Directly in line with the ‘ INLET FRESH AIR FROM OUTSIDE’ socket and from the ‘back’ or
‘mounting’ side of the appliance, insert the frost sensor filter cover and gently push the cable
into the groove running up the face of the main housing. Ensure that no undue stress is put
on the cable.
2.3.4 See also 3.2 for wiring centre connections.
2.4 Wall/surface fitting the HRX2 appliance
2.4.1 Refer to the diagram on page 6 to determine where the extents of the appliance are in relation
to the support brackets.
2.4.2 Rotate the two support brackets to a vertical position from their horizontal transit position.
2.4.3 Using the support brackets as a template, mark the positions for the two fixings.
2.4.4 Using 2 x 4mm (No.8) round/pan-head screws and appropriate anchors (not supplied), secure
the appliance.
2.4.5 Ensure that no cables are trapped behind the appliance and that the appliance is level front to
back and side to side.
2.4.6 Attach the four black self-adhesive ‘hook’ pads, one onto each corner indentation of the main
body. Attach the four white self-adhesive ‘loop’ pads, one to each corner of the cardboard
‘householder-instruction’ cover. Carefully fit the ‘householder-instruction’ cover by pressing to
engage the ‘hook and loop’ pads.