Siko AG26, Перевод оригинальной инструкции по установке

Страница: 32 / 48

AG26
Installation English
AG26 · Date 03.02.2022 · Art. No. 87451 · Mod. status 255/21
32
` The drive is to earthed via the flat connection with a strand section of
at least 2.5 ... 4 mm².
Basically, all connections are protected against external interference.
Choose a place of operation that excludes inductive or capacitive interfer-
ence influences on the actuator. When mounting the system keep a maxi-
mum possible distance from lines loaded with interference. If necessary,
provide additional installations including screening shields or metallized
housings.
Ethernet pin configuration
•
1
Port1: socket 4-pole M12 D-coded (
Fig. 4
).
•
2
Port2: socket 4-pole M12 D-coded (
Fig. 4
).
For accessory mating connectors and cable extensions refer to chapter
8
.
PIN Designation
1 Tx+
2 Rx+
3 Tx-
4 Rx-
1
Port1
2
Port2
3
Operating voltage
Fig. 4: Pin assignment
1
2 3
4 5
4
PE-connection
5
Digital inputs / outputs
Data transmission via Ethernet
The line length between two nodes must not exceed 100 m. Use only Eth-
ernet cables which correspond at least to category 5 (CAT 5) acc. to EN
50173 or ISO / IEC 11801. Use only cables with complete shield.
NOTICE
M12 D-Codiert 4-pol.
Buchse
2
3 4
1
viewing side = plug-in side
Port1 und Port2