15
NAME=
Used to specify a name for the adapter.
You can specify a name by using 0 to 9, A to Z, a to z, space
and -. (Note: Using Space or - as first or last character isn't
permitted.) The default name is "Serial Adapter".
(Default)
Serial
Adaptor Default device name.
xx… .xx "xx… .xx" is a character string with the length from 2 to 30.
R
Restore the default settings name="Serial Adapter".
?
Inquire the name of the local adaptor.
PARITY=
Used to specify parity bit setting of COM port.
The command will have 200 ms delay.
(Default)
N
None parity bit.
O
Odd parity.
E
Even parity.
?
Inquire the current setting.
PIN=
Used to designate a PIN. The default PIN is "1234". Paired
adapters should have the same PIN. This command is used to
designate a PIN. The default PIN is "1234" and the digits
should not be less than 4. Paired adaptors should have the
same PIN. The PIN can be set up with combinations of
numbers, English characters or both.
(Default)
1234
xx… .xx "xx… .xx" is a 4~16 digits string or English characters (with
capital or lower case characters.)
N
Cancel authentication by PIN.
R
Restore the default settings of PIN="1234"
?
Inquires the current PIN.
PROMPT=
Used to decide whether result messages are prompted when
Setup commands are executed. The result messages are:
OK/ERROR for command execution, or
CONNECT/DISCONNECT/Try Connect Device for
connection status.
