SIIG Cool USB 2.0/eSATA to SATA Docking Duplicator, Быстрое руководство по установке

Страница: 7 / 12

7
Duplicate Disk
The Duplicate function creates an exact copy of the
source hard disk drive onto the target hard disk drive.
This is a standalone function and works without
computer connection.
1.
Unplug the Cool USB 2.0/eSATA to SATA Docking
Duplicator from the computer.
2. Install the source hard disk drive and target hard
disk drive into the appropriate drive bay. The
target hard disk drive must be of equal or larger
capacity than the source hard disk drive.
3. Power on the Cool USB 2.0/eSATA to SATA Docking
Duplicator.
4. Press the Duplicate button, the upper Power LED
will flash for several seconds. When the flashing
stops, press the Duplicate button again to start the
duplication process. All 4 LEDs will light up
confirming duplication process is running. Do not
turn off or unplug the hard drives during the
duplication process.
Note : Typically, a 1TB hard disk drive will duplicate
in 4 hours (70MB/s average transfer rate) and a
500GB hard disk drive will duplicate in 1.25 hours
(110MB/s average transfer rate). Your results will
vary according to the speed and capacity of your
hard disk drives.
5. When the duplication process completes, only the
bottom Power LED will be on.
6. Power off the Cool USB 2.0/eSATA to SATA Docking
Duplicator and remove the target hard disk drive.