1
2
3
4
A) Wood Stud Installation
3
4
5
6
7
CAUTION:
Do not over-tighten bolts-doing so many cause unnecessary damage to the wall. Avoid excessive torque.
Next, pre-drill a 1/8" hole to a depth of approximately 2" in the wood stud at each marked location.
Place the wall plate against the wall and line up the mounting slots with the drilled holes. Check the bubble level to
verify that the wall plate is level.
For each location, insert a bolt (E) and washer (G1) into the wall.
Tools Required:
Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots that are in
alignment with the studs. You should mark four positions total.
2
1
Phillips head screw driver
Stud finder for drywall installation
Tighten the bolt with a 7/16" socket or open ended wrench by turning clockwise until tight.
CAUTION:
Do not release the wall plate until it is properly mounted and secured to the wall.
Attach the bubble level (G2) to the wall plate and with the help of an
assistant ensure the wall plate is level, position the wall plate against
the wall in the desired mounting location.
NOTE: When mounting to wood studs, the two wood studs must be a minimum of 16" apart.
Step1: Wall Plate Installation
7/16" Socket and Wrench
Electric drill, 1/8" (3mm) drill bit for wood stud installation and 5/16" (8mm) masonry bit for concrete/brick installation
Note: Please ensure that the bubble level (G2) is properly mounted on the wall plate prior to mounting the wall
plate.
Use a high-quality electronic stud finder to locate dead center of two
studs and mark their locations with a pencil (figure 1-a).
3
Содержание 04-0660A
Страница 6: ...Blank Page 6...
