Signode TENSION-WELD VXL-2000-Z, Руководство по эксплуатации, частям и безопасности

Страница: 33 / 40

33
#11 CONDITION: Strap weld time is erratic.
CAUSE REMEDY
Dirty or very dry valve in air motor valve housing. Add a several drops of airline oil into the air inlet of
the tool and cycle several times to lubricate. If the
problem persists, review the air motor valve housing
maintenance instructions found in this manual.
#12 CONDITION: Weld time is too long.
CAUSE REMEDY
Too much oil in the air supply system of the tool. Purge the tool of all excess oil. See instructions
Excess Oil Removal found in this manual.
#13 CONDITION: Weld handle is difficult to pull back.
CAUSE REMEDY
Spacer sleeve (Key 35) in tool housing is not
positioned correctly.
Disassembly tool housing and correctly
install/position the spacer sleeve.
#14 CONDITION: The cut-off has become difficult.
CAUSE REMEDY
1. Strap residue jamming cutter mechanism.
2. Strap cutter may require adjustment.
3. Cutter blade worn or damaged beyond
adjustability.
4. Broken or damaged cutter spring.
1. Clean parts as required.
2. Contact Signode for information on accessing
and adjusting the strap cutter.
3. Follow cutter blade replacement procedures.
4. Replace as required.
#15 CONDITION: Welded strap is misaligned.
CAUSE REMEDY
The 1/2" (12.7mm) strap guide is being used when
using 7/16" (11mm) strapping material.
Replace 1/2" (12.7mm) strap guide (Part No. 274105)
with 7/16" (11mm) strap guide (Part No. 014565).
#16 CONDITION: Strapping material does not easily fit into the strap guide.
CAUSE REMEDY
The 7/16" (11mm) strap guide is being used with 1/2"
(12.7mm) strapping material.
Replace the 7/16" (11mm) strap guide (Part No.
014565) with the 1/2" (12.7mm) strap guide (Part No.
274105).