Signode TENSION-WELD VXL-2000-Z, Руководство по эксплуатации, частям и безопасности

Страница: 14 / 40

14
WELDING MECHANISM & DRIVE GEARS
1. Remove the idler gear (27) from the pin
(30) and examine both parts for wear.
2. Remove the eccentric shaft (26) and
examine it for wear.
3. Lift the slider link (48) from the gear
housing (72). Examine the teeth on the
upper gripper (52) for wear. The upper
gripper can be replaced by removing the
pin (51).
4. Examine the teeth of the lower gripper
(78). If the part is to be replaced, it may
be removed by first removing the
mounting screw (87) from underneath,
then punching it out from underneath
through the two holes.
When reinstalling a lower gripper, use
Loctite "380 Black Max" (Signode Part
No. 274111) or an equivalent instant
adhesive to ensure the lower gripper will
be held securely. Note that mating
surfaces must be free of dirt and grease.
NOTE: When using 380 Black Max adhesive,
directly follow the manufacturers cleaning
and preparation instructions.
5. Remove th needle bearing (29) from the
housing by threading a 1/4 x 20 screw
through the bearing into spacer (86) refer
to Figure “C” on the following page.
Clamp the screw head in a vise and
lightly tap the casting to extract the
bearing. If bearing removal becomes
difficult use the detailed instructions on
the following page.