Signet 4630, Руководство пользователя

Страница: 14 / 48

14 #$%&(
Cl Zero
Calibration:
>
!œI–—I
!Z+IZ
Z( =O
Cl In Process
Calibration:
>
Z PQZ( =O
Cl Temperature
Calibration:
>
Enter process temperature from a reference thermometer: °C or °F. Units are set up in the
Options Menu. Example on Section 15.
Reset Cl to
Factory Cal:
>
This menu resets Cl readings, Zero Calibration Q)
!*H?HƒŸ[
pH Standard
Calibration:
>
(GG
Example on Section 13.
pH Slope
Calibration:
>
GBG
units apart. Example on Section 13.
Reset pH to
Factory Cal:
>
*GI Q)
!*H?HƒŸ[G
Chlorine Units:
ppm
>
@
Loop 1 Source:
Chlorine
>
G#B& Example on Section 16.
Loop 1 Rng: ppm
0.00 5.00
>
Select the minimum and maximum values for the current loop output. Units are derived from
]=( ?( = IJ
Loop 2 Source:
pH
>
G #B&
Loop 2 Rng: pH
00.0 14.00
>
Select the minimum and maximum values for the current loop output. Units are derived from
]B( ?( B IJ
/ *,
/ *
Factory settings shown
,
/$
=)K
For greater accuracy it is recommended that the initial calibration of the system should be in the following order:
1. Temperature
2. G ;G ?G G
A
3. Chlorine sensor
Y
Y + I
]* 8 "
Y G
The menus below are displayed here in the order seen when scrolling down through the Calibrate Menu.
=)K The next two pH calibration screens will be shown only when a valid pH sensor is detected.
P[
Q
P*Q
edit mode
PZQ
settings
ENTER ENTER
2s
ENTER
ENTER
;GA