9
www.signaturebrand.co
•
While the clippers are running, rapidly
move the lever from ‘close cut’ to ‘longer
cut’ a couple of times. Doing this each
time after you have finished using your
clippers helps to keep the blades clear of
cut hair. If your clippers stop cutting and
this does not help, this would indicate that
your cutting blades are dulled, replace
them with new blades
Shaver
Charging instructions
1. Make sure shaver switch is turned to OFF.
2. Attach the charging cable to the bottom
of the shaver, then connect to a 2 pin
adaptor plug (NOT INCLUDED).
3. Plug the charger into an electrical outlet
and switch on at the wall socket.
4. Once plugged in, the LED charger light on
the front of shaver housing will activate.
5. Charging time is 8-16 hours, do not
exceed 20 hours.
6. Ensure that the shaver is totally drained of
power before charging again.
7. The shaver can be used for approximately
7 days after the battery has been fully
charged.
Operating instructions
1. Once fully charged, switch off at the wall
socket and unplug.
2. Remove charger cord from shaver
housing.
3. Remove shaver cover and switch to ON.
4. Gently guide shaver along face and chin
to remove facial hair using short, back
and forth strokes. Note: Do not apply too
much pressure while shaving.
5. If you have not used an electric shaver
before, your skin may become irritated
after use. This is a natural reaction that
may last for a few days until your skin
adjusts the shaver.
6. When you have finished shaving, switch
OFF.
How to use the sideburn trimmer
1. Push the lever on the back of the shaver
to release the side burn trimmer.
2. Softly touch your skin at a right-angle
direction with the trimmer and trim slowly.
3. After using, push down the switch.
How to use the trimmer
1. Ensure that you have placed 1 x 1.5V AA
Battery into the battery compartment.
2. To attach either the nose trimmer or beard
trimmer attachment, place it over the
motor spindle and turn clockwise to locate
and lock.
3. To remove the attachment turn
anticlockwise.
4. Keep the motor and the battery dry at all
times as failure to do so may result in the
product malfunctioning.
5. Dry the blades completely before
replacing.
