8
SERVICE DEPARTMENT:
+44 (0) 333 220 6062
Blade alignment
•
Your clippers were carefully examined to
ensure that the blades were oiled and
aligned before leaving our factory.
•
Blades must be realigned if they
have been removed for cleaning or
replacement.
•
To realign the blades, simply match the
upper and bottom blades teeth up, point
for point. (End of top blade teeth should
be approximately 1.2mm back from
bottom blade.
•
If the blade alignment is incorrect, add
a few drops of oil to the blades, turn the
clippers on for a few moments, then turn
off and unplug.
•
Loosen the screws slightly and adjust,
tighten the screws after the blade is
aligned
Oil
•
To maintain your clippers in peak
condition, the blades should be oiled after
every 3-4 times of use.
•
ONLY use the correct oil to lubricate the
clippers
Power screw
•
The power screw permits you to adjust
the power. It has been adjusted before
leaving the factory. However, if the voltage
in your home is low, you may need to
readjust it.
•
To adjust, use a screwdriver to turn power
screw in a clockwise direction until the
arm strikes the coil, making a noise. Then
slowly turn power screw out (counter-
clockwise) just until noise stops. This is
now at the maximum power setting.
Blade lever
•
The lever is
conveniently located
near your thumb (if
you are right handed)
so it can easily be
adjusted while the
clippers are in your hand.
•
The lever adds versatility to your clippers
by allowing you to gradually change
the closeness of your cut without an
attachment comb.
•
When the lever is in the upper most
position, the blades will give you the
closest cut and leave the hair very short.
•
Pushing the lever downward gradually
increases the cutting length.
•
In its lowest position, the lever will leave
the hair approximately the same length as
a No1 comb.
•
The lever will also extend the use of your
blades since different cutting edge is used
in each setting.
•
In addition, if extremely heavy hair cutting
has jammed the blades, it will help you
remove hair that has become wedged
between the two blades without removing
the blades.
1.2mm
