10
SERVICE DEPARTMENT:
+44 (0) 333 220 6062
Cleaning And Care
Warning!
Only clean when shaver is
disconnected from charger and ensure that the
switch is turned to OFF.
•
After each use beard
and hair cuttings may
collect in foil. Clean
foil by pressing the
cover lock button.
This will release the
cover enabling you to brush out the hair
that has been collected. Take care not
to disturb the blades as these are very
delicate.
•
If necessary, use brush to clean hair
trimmings from exposed shaver cutting
heads.
•
Recharge if necessary.
•
To clean the trimmer unit, take the
attachment off as directed and run under
warm water.
•
Make sure that the attachment is dried
thoroughly before storing or reattaching to
the trimmer.
•
Wipe all external surfaces of power units
with a soft damp cloth.
Clippers:
•
Switch the appliance off, unplug from the
mains.
•
Wipe over the casing using a soft damp
cloth( If necessary a little washing up liquid
may be used) Do not immerse the unit in
water or and other liquid.
•
Remove and wash the guards in warm
soapy water.
•
Ensure all parts are dried thoroughly with
a soft towel before reusing.
•
Do not use harsh abrasives or cleaners.
•
Use the supplied brush to clean the
clipper blades after each use.
•
Oil the clipper blades after every 3 or so
uses.
PLEASE NOTE:
•
DO NOT press the foils.
•
DO NOT open the foils with a screw driver.
•
DO NOT use running water to clean the
shaver.
•
DO NOT charge or store near a fire or
heater, direct sunlight, or in vehicle during
warm weather.
Press
WARNING:
DO NOT IMMERSE ANY PART OF THE
APPLIANCE IN WATER
