OPERATIONS
AND
FEATURES
Using
the
Remote
Control
Power
This will turn the unit ON
and OFF. When the unit is
turned back ON, the system
will recall the last heat
setting used. Store flame
and Heating setting.
Adjust
Brightness
This allows you to raise or lower
the level of flame brightness.
Note: when the unit is turned
off that the LOGS completely
die out for 3 seconds.
Timer
This allows you to set the
fireplace to automatically shut
OFF after the amount of time
displayed on the screen, the
timer can be set from 10
minutes to 9 hours, the display
shows 10, 20, 30, 40, 50, 1H, 2H,
3H, 4H, 5H, 6H, 7H, 8H, 9H. Do
not operate fireplace while
unattended.
Adjust
Temperature
This allows programming of the
thermostat. The fireplace can
be used without the heater if
desired. Simply cycle through
the function until no
temperature is displayed. Press
and hold the down arrow for
five seconds to switch
temperature readout from
℉
(Fahrenheit) and
℃
(Celsius)
and back. Must be in Heat
mode.
Dynamic
Embers
This function will make the
embers of the fire
automatically glow dimmer and
brighter creating a more
realistic fire effect.
Using
the
Control
Panel
This will turn the unit ON
and OFF. When the unit is
turned back ON, the system
will load default factory
settings.
This function will cycle
through the five
different levels of flame
brightness.
Power
Adjust
Brightness
This allows programming
of the thermostat. The
fireplace can be used
without the heater if
desired. Simply cycle
through the function until
no temperature is
displayed. Press and hold
the button for five seconds
to switch temperature
readout from
℉
(Fahrenheit) and
℃
(Celsius) and back.
Adjust
Temperature
This will allow you to set the
automatic shutoff on the
fireplace. Dynamic Embers
will work on the unit hold 5
seconds when beeps press
again. To stop embers press
timer button then hold for 5
seconds.
Timer/Dynamic
Embers
MODEL#:
EF16-23
Page 11 of 15