SignaMax SC30010, Справочное руководство CLI

Страница: 349 / 671

Chapter 11
| Interface Commands
– 349 –
Related Commands
capabilities (344)
speed-duplex (349)
shutdown
This command disables an interface. To restart a disabled interface, use the
no form.
Syntax
[ no ] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then re-enable it after the problem has been
resolved. You may also want to disable a port for security reasons.
Example
The following example disables port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#shutdown
Console(config-if)#
speed-duplex
This command configures the speed and duplex mode of a given interface
when auto-negotiation is disabled. Use the
no form to restore the default.
Syntax
speed-duplex { 100full | 100half | 10full | 10half }
no speed-duplex
100full - Forces 100 Mbps full-duplex operation
100half - Forces 100 Mbps half-duplex operation
10full - Forces 10 Mbps full-duplex operation
10half - Forces 10 Mbps half-duplex operation
Default Setting
◆ Auto-negotiation is enabled by default.