www.signamax.com
I-1100 SERIES
QUICK START GUIDE
4
Ground the Media Converter
1.
This equipment must be grounded. Never defeat the
ground conductor or operate the equipment in the
absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that
suitable grounding is available.
2.
Attach a lug (not provided) to a #12 AWG (PoE
converter) or #18 AWG (non-PoE converter)
minimum grounding wire (not provided), and connect
it to the grounding point on the converter rear panel.
Then connect the other end of the wire to ground.
Caution:
The earth connection must not be
removed unless all supply connections have
been disconnected.
Note:
The device must be installed in a
restricted access location. It should have a
separate protective earthing terminal on the
chassis that must be permanently connected
to earth to adequately ground the chassis and
protect the operator from electrical hazards.
!
Connect Power
1.
Insert the positive and negative wires into the PWR1
(+,-) and PWR2 (+,-) on the terminal block connector.
2.
Tighten the screws to prevent the wires from
loosening.
PWR 1
PWR 2
