SignaMax 065-7910HPOEP, Руководство пользователя, Страница: 52 / 89

9 LLDP
52
and the default value is 4.
Tx Delay
：
The delay period between successive LLDP packets which are initiated by port
parameter changes. The range is from 1 to 8192, and the default value is 2.
Re-init Delay
：
in the case of LLDP Status mode changes, the port will initialize the protocol
state machine, and the switch will need to wait for Re-init Delay to be able to start the next
initialization. The range of this value is from 1 to 10 seconds, and the default value is 2.
Fast Count
：
The number of fast sending packets. It is in the range of 1 to 10, and the default
value is 3.
Caution:
Tx Interval and Tx Delay both should be smaller than TTL; otherwise it will cause the
neighbor device be unable to receive the LLDPDU from the current device after aging.
9.2 Neighbor Information
This page shows the Local Port, Chassis ID of a local device, and the Remote Port ID,
System name, Port description, System Capabilities, and Management Address of a neighbor
device.
9.3 LLDP Statistics
This page shows the statistics of Tx Frames, Rx Frames, Rx Error Frames, Discarded
Frames, TLVs discarded, TLVs unrecognized, Org.TLVs discarded, and Age out packet
counts of LLDP packets on each Ethernet port.