Signamax
FO-065-7330 / 7340 Ethernet Switch
User’s Manual
10
How to Install Module
Consult the following illustrations before installation.
Step 1:
Make sure the power is switched off. The module is not hot-
swappable.
i
It may cause electric shock or any possible damage to the switch if the
power is not switched off.
Step 2:
Remove the module from the static-free container.
Step 3:
Unscrew the cover plate of the expansion slot.
(The slot for single-port module is located at the right side of the
switch.)
Step 4:
Remove the plate.
(Keep it for future use when you decide to remove this module
later.)
Step 5:
Carefully slide the module into the slot, following the internal
plastic guide rails.
Step 6:
Once it is fully slid in, snap in the module to make a proper
connection.
Step 7:
Fasten the module screws then.
Step 8:
Finally, turn on the power.
Figure 4: Removal of cover plate Fiber module being installed
