SignalFire AI-6C, Руководство пользователя, Страница: 11 / 16

17 18
CHAPTER
Ⅳ
FIBER STRIPPING AND PUT INTO HOLDER
With the yellow plastic laye as the
boundary, the scale is between 13 to
18. the white skin layer should be
longe than the vellow layer of 5mm,
placed it in the scale 10-12 or so(near
the ubber pad about 2mm or less) Scale is between 13 to 18 To the cladding layer, the scale is
between 10 to 12
Instructions for put fiber into holder:
Jumper fiber(pigtail fiber) Rubbe insulated fiber Bare fiber
Gtail Fiber/jumper Fiber
Gtail Fiber/jumper Fiber
Rubber insulated fiber Rubber insulated fiber
Cable/bare fibe Cable/bare fibe
Note:
1. After all the optical fibers are stripped and placed according to the above length, the front end should be at least completely
pressed by the fiber compression board on the right of the blade, otherwise it will be continuously cut.
2. Please keep the four pressure fiber rubber pads clean, no waste fiber and other sundries, avoid contact with alcohol and other
corrosive liquids.
FIBER STRIPPING AND PUT INTO HOLDER
Note:
1. Put the fiber into the blue V-shaped slot when laying out the fiber, and the top of the fiber is close to the center of the electrode. If it is too
far from the center of the electrode, it will prompt you to re-lay the fiber.
2. The top of the optical fiber must not exceed the center of the electrode.