CHAPTER I
OPERATION KEY COMBINATION FUNCTION
05
OPERATION KEY COMBINATION FUNCTION
06
Introduction of operation keys and parts
The fusion splicer machine is mainly used
fopermanent splicing fiber, the machine can
continue to splice ordinary rubber insulated
fiber cable, jumper wire and a cladding diameter
of 80um-150um, single mode,multimode and
other quartz-based dispersion shifted fiber.
The operation process should be taken to keep
clean free subjected to strong vibration or shock
ORESET
Press the reset key to reset the propulsion motor, adjustable
motor, and focusing motor to their original. When the Reset
button light is on, it indicates the reset is in process. If it turns
off within 5 seconds automatically that means the reset is
successful, otherwise the reset is failed.
CONTINUE
When the pause function is on, please press the Contkey
to continue the next operation
MAGNIFICATION KEY
image magnification between 200 and 300 times display switch
COPOWER
long press to turn on or off.
Visual fault locator
Constantly lit/Flashing/Off/switching between three states
Switch wavelength
85nm/1300nm/1310/nm/1490nm/1550nm/1625nm switching
between six states
Switch test unit
dBm/db/uw Switch between three units, power display range:
-70-450dBm. Error display Error
power meter and optical modules switch
Turn on/off power meter and optical modules
The four function keys at the bottom of the screen, in addition to the basic functions (the first chapter introduces the
operation keys and parts), there are also some combined functions for daily maintenance of the machine.
1.Mandatory upgrade mode:
in the shutdown state, press and hold the reset key and the power button, and the
machine enters the mandatory upgrade mode.
Usage :In this mode, connect the phone again-zhuoshizhangz,firmware updates are more stable, faster,
and can force a firmware refresh.When normal upgrades fail, it's easier to succeed with this feature.
2.Self-check of optical fiber fusion splicer:
in the shutdown state, press and hold the continue button and the
power button at the same time, and the machine enters the self-check mode.
Usage: When the welding machine is not working normally and the hardware is suspected to be out of order, it can
be confirmed by self-inspection. For example, adjusting fiber is normal, but there is no welding fire, you can check
whether the FBT is out of order.
After entering the self-check, the test countdown will be displayed at the bottom of the screen. After all the 12 items
are self-checked, the red font will be displayed, and the status of error after the project means that the hardware has
faults.At this point, the firmware can be upgraded first (please refer to 1 mandatory upgrade mode for specific
operation). If the fault is still there, please contact the after-sales service to deal with it.
The meaning of the 12 self-checking items as following
01 Image processing
02 Data Rom
03 Data Ram
04 Controller
Report an error,please check again. If the error is still reported,
please contact after-sales service
05 Motor: PL PR AL AR
06 Focusing Motor: X Y
report an error,Please contact the after-sales service
07 Camera: X Y
report an error, first clean up the lens, upgrade the firmware.If the fault
persists,Please contact the after-sales service.
Image processing
Data Rom
Data Ram
Controller
Core regulating motor and propulsion
motor, each one has 2
Focusing motors :2
Camera :2
