DAILY MAINTENANCE
41
DAILY MAINTENANCE
42
10.Machine self-check. First, shut down the machine, then press the triangle button and turn it on, and then
let the machine enter the self-check mode. Wait for half a minute or so to see the self-check result of the
machine. If there is a red option, it means there is something wrong with the machine. What do the first
eleven items represent respectively, and whether each item needs to be listed in detail, we need to
cooperate with the research and development to explain.
11.Force upgrade mode. Press the reset key (leftmost key) and the power button at the same time, and the
machine enters the forced update mode. At this time, open the phone APP and connect it to the machine.
Then click software update -- check the firmware version -- update the firmware, and upgrade the firmware
program of the machine to the latest. When updating the firmware, keep the phone not away from the
machine and try not to answer calls.
12.Always suggest that the cutting surface does not meet the requirements, resulting in no welding. This is
mainly the following two cases, one is V groove dirty, optical fiber did not enter the groove (as shown in the
figure on the left), in this case, take out the optical fiber with the artist's knife along the bottom of the slot V
groove back and forth after scraping a few times, and then brush clean V groove with wool brush, finally press
the reset key on the line. The other is that the lens fogs up, causing the optical fiber to be unable to be identified
effectively (see the image on the right). In this case, wipe the lens with a clean cotton swab.If that still doesn't
work, just blow the dryer against the cold air.
9.
Easily broken fiber -- -- if it is broken from the welding point, generally is the current is not appropriate,
redo the discharge calibration on the line. If it is from the position of the fixture fracture is caused by the
quality of optical fiber, this case leather fiber and fiber optic cable will need to put the fiber rubber coating
layer left two to three millimeters not peeling, clamping device pressure down, pressure on the coating
layer can be. The tail fiber needs to press the front end of the clamp onto the white rubber skin of the inner
layer.
There is a coating layer on the parts
pressed by leather fiber and cable
clamps
The front end of tail fiber fixture
pressed on the inner layer of
white rubber
